Find a chimney sweep: cleaning and combustion system inspection

The chimney sweep cleans chimneys, fireplaces and combustion systems and checks whether they burn safely and cleanly. What looks like tradition is in fact fire protection and air pollution control: soot deposits are the most common cause of chimney fires, and a poorly adjusted combustion system pollutes the air and costs you money in equal measure.

What a chimney sweep does

A chimney sweep cleans chimneys, connector pipes and combustion systems, inspects fireplaces and wood-burning stoves, carries out the prescribed combustion system inspections and emissions measurements, and assesses the fire safety of installations. For new installations, the flue arrangement is checked before the system is commissioned.

Cleaning and inspection duties

Combustion systems are subject to periodic cleaning and inspection requirements. How often they are cleaned depends on the fuel and how they are used: a regularly used wood-burning system needs cleaning more often than one used only occasionally. The requirements are regulated at cantonal level and are usually administered through the municipality.

District allocation instead of free choice

In many cantons and municipalities, the area is divided into chimney-sweep districts, and the responsible district chimney sweep is in charge of the legally required work. Other cantons have introduced free choice. Check this with your municipality before engaging a company; otherwise you may pay for a service that you would receive from another authority anyway.

Think about the chimney too when replacing the heating system

If you switch from oil or gas to a heat pump, you no longer need the chimney for the heating system. A disused chimney must be taken out of service properly so that no moisture or odours develop. If a fireplace or wood-burning stove remains in use, the draught conditions in the chimney may change, which the chimney sweep should assess.

Heating properly with wood

A large share of fine particulate pollution from wood-burning systems is caused by incorrect lighting and wood that is too damp. Dry wood with less than twenty per cent moisture, lighting from the top and sufficient air during the ignition phase significantly reduce emissions and soot formation. The chimney sweep can advise on this, and the advice is usually part of the inspection visit.

What you should prepare

Ensure clear access to the combustion system, cleaning doors and chimney access, and remove combustible materials from around the installation. Keep the installation documents ready, especially for newly installed stoves. If a defect is identified, ask for a written notice with a deadline, so that the rectification is documented.

  1. Home
  2. Tradespeople
  3. Chimney sweep